Cisco 300-365 Exams Dumps For Preparation

Question No. 1

Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.)

• A. |f Ethernet and wireless are available, it attempts to discover only via Ethernet.
• B. if Ethernet is disconnected, it attempts to connect wirelessly using AWPP.
• C. if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC.
• D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless.
• E. |f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option.

Question No. 2

A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue?

• A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller.
• B. Under the SSID, make sure that 802.1 Iris configured and running for the clients.
• C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly.
• D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group.

Question No. 3

What is the maximum number of monitor reports that can be created by using Cisco AVC and Cisco Prime Infrastructure?

• A. 10
• B. 20
• C. 30
• D. 40

Question No. 4

An engineer is attempting to send multicast data to all multicast routers in the network with ID 338789750.

Which IP address should be used?

• A. 224.0.0.1
• B. 224.0.0.2
• C. 224.0.0.4
• D. 224.0.0.3