Try Latest Dell EMC DCAN-100 Exam Questions – Pass In First Attempt

DCAN-100 Braindumps DCAN-100 dumps DCAN-100 Exam DCAN-100 Exam Dumps DCAN-100 Practice Test DCAN-100 Questions Dell EMC

Success in Dell EMC Certified Networking Associate DCAN-100 exam is 100% by preparing the up-to-date DCAN-100 exam questions and doing practice through best practice DCAN-100 exam test software. Dell EMC Networking Associate DCAN-100 exam dumps material leads towards success by doing practice with DCAN-100 exam test software and you leave no room to miss any key aspect of the DCAN-100 exam because of the real simulation software. Before purchase of the actual Dell EMC DCAN-100 exam you can take DCAN-100 exam demo free of cost!

♥♥ 2018 NEW RECOMMEND DCAN-100 Exam Questions ♥♥

DCAN-100 exam questions, DCAN-100 PDF dumps; DCAN-100 exam dumps:: (57 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Dell EMC DCAN-100 Dumps Exam Questions and Answers:

Question: 1

A customer is using the following subnets in their environment:
The customer has run out of IP space in their desktop subnet. More IPs for desktops must be provided with the least disruptive change to the environment.
Which desktop subnet meets the requirements?


Answer: D

Question: 2

Which of the following is the IPv6 loopback?

A. 1: :/128
B. : :0/128
C. : :1/128
D. 1::1/0

Answer: C

Question: 3

A technician needs to create multiple subnets to make sure there are at least 20 available IP addresses per subnet.
Which three subnets meet the requirements for the network. (Choose three.)


Answer: B,C,E

Question: 4

A technician is applying a switch configuration to an N-Series switch to provide Internet access to all connected subnets. The technician has connected a computer and assigned it an IP address, subnet mask, DNS, and gateway address. The technician is unable to browse the Internet from that computer.
What is causing the issue?

A. DHCP Snooping has blocked the host.
B. The static routes in the configuration file are incorrect.
C. The “ip helper-address” command is configured on the switch.
D. Spanning Tree blocked the port going to the PC.

Answer: B

Question: 5

A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added.
What is a possible cause of this issue?

A. The existing switch has not been configured with the command “hostroutesaccept”.
B. The new switch’s interface is in the wrong subnet to form a RIP relationship.
C. The “ip helper-address” command has not been configured on the existing switch.
D. The other switch is not a root bridge and cannot form an RIP relationship.

Answer: B

Question: 6

A technician needs to add an IP for management. When adding an IP, the technician received the following message:
Console (config-if-vlan1) #ip address
Failed to set IP address on interface.
What is causing this message?

A. An IP cannot be assigned to VLAN 1.
B. A subnet address cannot be assigned to a VLAN.
C. /27 cannot be used in an address command.
D. A host address cannot be assigned to a VLAN.

Answer: B

New Updated DCAN-100 Exam Questions DCAN-100 PDF dumps DCAN-100 practice exam dumps: