Try Latest Juniper JN0-661 Exam Questions – Pass In First Attempt

JN0-661 Braindumps JN0-661 dumps JN0-661 Exam JN0-661 Exam Dumps JN0-661 Practice Test JN0-661 Questions Juniper

Success in Juniper Service Provider Routing and Switching JN0-661 exam is 100% by preparing the up-to-date JN0-661 exam questions and doing practice through best practice JN0-661 exam test software. Juniper Service Provider Routing and Switching JN0-661 exam dumps material leads towards success by doing practice with JN0-661 exam test software and you leave no room to miss any key aspect of the JN0-661 exam because of the real simulation software. Before purchase of the actual Juniper JN0-661 exam you can take JN0-661 exam demo free of cost!

♥ VALID JN0-661 Exam Questions 2018 ♥

JN0-661 exam questions, JN0-661 PDF dumps; JN0-661 exam dumps:: https://www.dumpsschool.com/JN0-661-exam-dumps.html (133 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest Juniper JN0-661 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

Your network engineer reported that they lost BGP connectivity to the neighbor 192.163.6.4 one hour ago, for five to ten minutes.
What are two ways to determine what happened? (Choose two.)

A. Run the show bgp neighbor orf 192.163.6.4 detail command.
B. View the information on the BGP monitoring station at 192.168.44.100.
C. Run the show log bgptrace command and search for the time of the lost connectivity.
D. Run the show log messages command and search for the time of the lost connectivity.

Answer: B, D

Question: 22

Refer to the exhibit.

Referring to the applied drop profile shown in the exhibit, if the buffer is 30 percent full, what is the probability of traffic being dropped?

A. 25 percent
B. 30 percent
C. 50 percent
D. 75 percent

Answer: A

Question: 23

Referring to the exhibit, you have configured an L3VPN that connects Site-1 and Site-2 together, but the BGP routes are being hidden on the PE routers. The topology in this scenario is shown below.
Site-1 > PE-1 > P-1 > P-2 > PE-2 > Site-2
Which two acttions would allow communication Site-1 and Site-2? (Choose two.)

A. Disable CSPF on under MPLS on P-1 and P-2.
B. Configure DGP on P-1 and P-2.
C. Enable RSVP for all interfaces on P-1 and P-2.
D. Enable LDP for all interfaces on all routers.

Answer: C, D

Question: 24

A layer 2 circuit (RFC 4447) is established between two PE routers to provide connectivity between two customer sites. Which two statements related to this deployment are true?

A. Kompella encapsulation is used in the data plane communications.
B. LDP must be used for the control plane communications
C. BGP must be used for the control plane communications.
D. Martini encapsulation is used in the data plane communications.

Answer: B, D

Question: 25

Referring to the exhibit, which router will be the RP?

A. R4 for all groups
B. R1 for group 224.1.1.11 and R4 for all other groups
C. R1 for all groups
D. R4 for group 224.1.1.12 and R1 for all other groups

Answer: A

Question: 26

You must ensure that r1’s IPv4 loopback address exists in r3’s inet 0 routing table
Referring to the exhibit, which statement is true?

A. An IPv4 unicast realm can be enabled on each router.
B. A policy can be configured on M to redistribute 172.16.100.1/32 into OSPFv2, which would cause r3 to eventually learn the route and place it into inet0.
C. A RIB group can be configured on r3 to copy that route into inet 0 because 172.16.100.1/32 exists in r3’s inet6.0 table
D. A policy can be configured on r1 to redistribute 172 16 100 1/32 into OSPFv3, which would cause r3 to eventually learn the route and place it into inet 0.

Answer: C

New Updated JN0-661 Exam Questions JN0-661 PDF dumps JN0-661 practice exam dumps: https://www.dumpsschool.com/JN0-661-exam-dumps.html